La Rocca Expres VE2, Руководство пользователя

Страница: 20 / 25

MANUAL DE USUARIO | USER’S GUIDE
VE2 | VE3
© LA ROCCA EXPRÉS S.A. | www.larocca.es 20
has been served, you can press again the
hot water button to stop it.
There is a hot water button dose for every
group of the machine. Each hot water dose
button can be programmed with a different
dose.
5.3 STEAMING AND FROTHING MILK
• Place the steam wand (10 or 16) over
the working tray and move the steam
lever (2 or 8) up or down (following your
preference) for a few seconds to allow
the condensed water to be ejected.
That is not necessary if the steamer has
been used recently (less than 5
minutes)
• Close the steam tap (take the lever (2 or
8) to the middle position) when only
steam comes out (2-3 seconds)
• Let immerse the steam wand (10 or 16)
into the milk jug.
• Open the steamer by moving again the
lever (2 or 8) up or down.
• Keep the steam wand immersed while
the steam comes out. If you want
frothed milk, then you must have the
steamer’s end near the milk surface (be
care ful, if the steamer’s end reaches the
surface, it will splash, with risk of burns
for the user)
• Once the desired temperature or
frothed has been reached, close the
steamer by taking the lever to the
middle position.
• After the process is finished, put the
steam wand over the drip tray and open
the steam tap for a few seconds to
clean remains of milk in the wand.
• Close the tap and clean the outside of
the steam wand with a damp cloth to
prevent the nozzle blockage.
6. PROGRAMMING
6.1. BUTTON FUNCTION
While programming, the dose buttons are
used with different functions, that usually
are the following:
Out of the programming modes, the dose
buttons return to its original functions:
6.2. PROGRAMMING THE DOSAGE
To program the different doses of each
group, you must do it with the filterholder
filled with ground coffee each time you
program a dose in order to get the most
accurate programming.
• With the machine on stand-by mode,
press the continuous button for 5
seconds until the LCD shows the
following message as the continuous
button light start to blink.
• Within the following 30 seconds you
have to press the button of the dose that
you want to program, so load the
filterholder
with ground coffee
adequate to this dose and insert it on
the group. Place the cup or cups below
the coffee spout. Press once the button
of the dose and wait for the coffee to fill
the cup.
• When the desired volume has been
reached, press again the dose button
and the coffee will stop pouring. Now
the dose is programmed.
• You’ll be back to the programming
screen on the LCD. You can program
another dose following the same steps
from the “doses settings” screen or
abandon the dose programming by
pressing 3 times the “continuous”
button.
• The hot water doses are programmed
the same way as a coffee dose.
• All the doses programmed at group 1
will copy to the other groups. If you
want different programming for each