ii
Charger Location
•
Provide at least 6 inches of free space left/right, and at least 6-inches of free space top/bottom for proper
cooling.
•
Do not operate this unit in a closed-in area or restrict ventilation in any way.
•
Do not set any battery on top of this unit.
•
Never allow battery electrolyte to drip on this unit. Take care when reading the specific gravity or filling
the battery.
•
Never place this unit directly above a standard flooded battery. Gases from the battery will corrode and
damage equipment.
•
A sealed maintenance free or valve regulated lead acid (VRLA) battery may be placed below this
equipment.
•
Do not mount directly above another heat source.
•
The charger must be mounted upright as to promote convection air flow through the external heat-sink.
•
See Installation & Mounting sections.
Check for Damage
Prior to unpacking the product, note any damage to the shipping container. Unpack the product and inspect the
exterior of product for damage. If any damage is observed, contact the carrier immediately. Continue the
inspection for any internal damage. In the unlikely event of internal damage, please inform the carrier and contact
La Marche for advice on the risk due to any damage before installing the product. Verify that you have all the
necessary parts as per your order for proper assembly.
CAUTION:
Failure to properly file a claim for shipping damages, or provide a copy of the claim to La
Marche, may void warranty service for any physical damages reported for repair.
Returns for Service
Save the original shipping container. If the product needs to be returned for service, it should be packaged in its
original shipping container. If the original container is damaged/unavailable, make sure the product is packed
with at least three inches of shock-absorbing material to prevent shipping damage.
La Marche is not responsible
for damage caused by improper packaging of returned products.
Inspection Checklist
Enclosure exterior is not marred or cracked.
All externally accessible hardware and connections are tight.
All items on packing list have been included.
Precautions
•
Do not operate this system in direct sunlight, in contact with fluids, or where there is excessive dust or
humidity.
•
Allow adequate space for proper ventilation. (See Charger Location & Installation Mounting sections)
•
Connect the charger AC input wiring to an appropriately rated circuit. The AC circuit should be able to
continuously support the charger’s full rated input
current and have an upstream OCPD at least rated to
meet or exceed that of the charger’s input fuses.
•
Do not attempt to operate the LMESpro with the cover removed; lethal voltages exceeding 400V inside.
