49
In order to establish proper communication between the display and outdoor sensor it is
important that they be set up as follows:
1.
Bring any units outside, inside and place all units 3-5 feet apart with nothing in-
between them.
2.
Remove batteries from all units.
3.
Press any of the buttons on the display at least 10 times to clear the memory.
Verify that the display is blank before proceeding.
4.
Using good quality alkaline batteries, place the batteries back into the wireless
temperature sensor(s); making sure that they are installed according to the
diagrams in the battery compartment.
5.
Taking care not to press any buttons, re-install the batteries in the weather station
according to the diagram in the battery compartment.
6.
Do not press any buttons for at least 15 minutes after installing the batteries.
(This is to let them establish a good connection.)
ABOUT WWVB RADIO CONTROLLED TIME
The NIST (National Institute of Standards and Technology—Time and Frequency
Division) WWVB radio station is located in Ft. Collins, Colorado, and transmits the exact
time signal continuously throughout the United States at 60 kHz. The signal can be
received up to 2,000 miles away through the internal antenna in the weather projection
station. However, due to the nature of the Earth’s Ionosphere, reception is very limited
