6 |
P a g e
Interference:
•
Consider electronics in the signal path between the sensors and your station.
•
Simple relocation of the sensors or the station may correct an interference issue.
•
Windows can reflect the radio signal.
•
Metal will absorb the RF (radio frequency) signal.
•
Stucco held to the wall by a metal mesh will cause interference.
•
Transmitting antennas from: ham radios, emergency dispatch centers, airports, military
bases, etc. may cause interference.
•
Electrical wires, utilities, cables, etc. may create interference if too close.
CAN I CHANGE BATTERIES IN MY SENSORS WITHOUT
LOSING DATA?
We designed this station for convenience, so that a simple change of batteries does not lose
data or require you to power down your station.
•
When Battery Indicator shows in the Outdoor Sensor area, replace batteries in your Outdoor
Sensor.
•
Then hold the SENSOR button for 3 seconds and your station will search for your sensor.
FACTORY RESET: HOW DO I FACTORY RESET MY STATION?
To factory reset your station:
1.
Hold the DATE and RAIN buttons together for 5 seconds.
2.
When your station resets it will look for all sensors. Allow at least ten minutes to reacquire
the sensors.
HOW DO I VIEW MY HI AND LO MIN/MAX READINGS?
Your high and low temperature and humidity readings are recorded with time and date of
occurrence. Each time a new high or low reading is recorded, that reading with time and date of
occurrence will show.
Press and release the MIN/MAX button to toggle MIN/MAX readings with time/date stamp.
These readings will be from the time the station was setup. Time and date of the Min or Max
reading will show.
Order:
•
Indoor Minimum Temperature Record
•
Indoor Maximum Temperature Record
•
Outdoor Minimum Temperature Record
•
Outdoor Maximum Temperature Record
HOW DO I RESET MIN/MAX READINGS?
Reset MIN/MAX Readings (each reset individually):
•
Press the MIN/MAX button to view individual readings.
•
Hold the MINUS button for five seconds to reset the individual value.
