14
The WS-9153U-IT is able to receive signals from 2 additional temperature sensors.
The following are instructions for the set-up of temperature sensor units with the WS-
9153U-IT. These extra sensors can be purchased through the same dealer as this
unit.
1.
Remove all the batteries from the receiver and sensor(s) and wait 60 seconds.
During these 60 seconds, press any button 20 times to discharge any excess
power.
2.
Insert the batteries to the first temperature sensor.
3.
Within 30 secondss of powering up the first sensor, insert the batteries to the
Weather Station. Once the batteries are in place, all segments of the LCD will
light up briefly. Following the indoor temperature and humidity, time as 12:00,
and calendar will be displayed. If they are not shown in LCD after 60 seconds,
remove the batteries and wait for at least 60 seconds before reinserting them.
4.
The outdoor temperature from the first sensor (channel 1) should then be
displayed on the Weather station. If this does not happen and the signal
reception icon is not shown, after 2 minutes, the batteries will need to be
removed from both units and reset from step 1.
5.
Insert the batteries to the second sensor as soon as the outdoor temperature
readings from the first sensor are displayed on the Weather station.
NOTE: You must insert the batteries into the second sensor within 10
seconds of reception of the first sensor.
6.
The outdoor temperature from the second sensor and the "channel 2" icon
should then be displayed on the Weather Station. If this does not happen after 2
minute, the batteries will need to be removed from all the units and reset from
step 1.
7.
Insert the batteries to the third sensor as soon as the "channel 2" icon and
outdoor data are displayed on the Weather Station. Then within 2 minutes, the
channel 3 outdoor data from the third sensor will be displayed and the channel
icon will shift back to "1" once the third sensor is successfully received. If this is
not happen, user shall restart the setting up from step 1.
NOTE: You must insert the batteries into the third sensor within 10
seconds of reception of the second sensor.
IMPORTANT: Transmission problems will arise if the setting for multiple
sensors is not followed as described above. Should transmission problems
occur, it is necessary to remove the batteries from all units and start again
the set-up from step 1.
VI. VIEWING AND OPERATING WITH MULTIPLE REMOTE TEMPERATURE
SENSOR UNITS
1.
To view the temperature of a different remote temperature sensor unit,
press and release the
CH
button. A shift from one “boxed” number to the
next should be observed in the OUTDOOR LCD.
2.
To view the Minimum/Maximum temperature: first select which remote
temperature sensor to read data from (indicated by the “boxed” number),
then press the
OUT
button. Pressing this button once will display the
minimum temperature, and the date and time the data was recorded.