9
after 60 seconds, remove the batteries from both units and wait for
at least 60 seconds before reinserting them.
4.
The outdoor temperature and humidity data from the first
transmitter (channel 1) and the signal reception icon should be
displayed on the Weather Station. If this does not happen after 2
minutes, remove the batteries from both units, and then restart the
process from step 1.
5.
Insert the batteries in the second transmitter as soon as the signal
reception icon and outdoor data are displayed on the Weather
Station. Then within 2 minutes, the channel 2 outdoor data from the
second transmitter and the "channel 2" icon should be displayed on
the Weather Station. If this does not happen after 2 minutes,
remove the batteries from both units, and then restart the process
from step 1.
Note :
You must insert the batteries into the second transmitter
within 45 seconds after the Weather Station displays the
information of the first transmitter.
10
6.
Insert the batteries in the third transmitter as soon as the "channel
2" icon and outdoor data are displayed on the Weather Station.
Then within 2 minutes, the channel 3 outdoor data from the third
transmitter will be displayed and the channel icon will shift back to
"1" once the third transmitter is successfully received. If this does
not happen after 2 minutes, remove the batteries from both units,
and then restart the process from step 1.
Note:
You must insert the batteries into the third transmitter within
45 seconds after the Weather Station displays the information of
the first transmitter - or immediately after reception of the second
transmitter is finished.
7.
The distance between the Weather Station and the transmitter
should not be more than 330 feet
to ens
ure sufficient 915 MHz
transmission. (See notes on “
Positioning” and “915 MHz
Reception
”).
IMPORTANT:
Transmission problems will arise if the setup for additional sensors is not
followed as described above. Should transmission problems occur, it is
11
necessary to remove the batteries from all units and start again the set-up
from step 1.
Note:
If the signal reception is not successful on the first frequency of
915MHz for 45 seconds, the frequency is changed to 920MHz and
the learning is tried for another 45 seconds. If it is still not
successful the reception is tried for 45 seconds on 910MHz. This
will also be done during re-synchronization.
When the weather station is receiving the WWVB time signal, the
outdoor transmitter data signal will temporarily not be received by
the weather station. During this short period of time, the outdoor
readings shown on the weather station will not be renewed until the
WWVB time signal is successfully received.
TO INSTALL AND REPLACE BATTERIES IN THE THERMO-
HYGRO TRANSMITTER
The Thermo-Hygro Transmitter uses 2 x AA, IEC, LR6, 1.5V batteries. To
install and replace the batteries, please follow the steps below:
1. Remove
the
cover.
2.
Insert the batteries, observing the correct polarity (see marking).
12
3.
Replace the battery cover.
Note:
When changing batteries in any of the units, all units
need to be reset by following the setup procedures.
This is due to a random security code assigned by the
transmitter at start-up. This code must be received
and stored by the Weather Station in the first 3
minutes of power being supplied to the transmitter.
TO INSTALL AND REPLACE BATTERIES IN THE WEATHER
STATION
The Weather Station uses 2 x C, IEC LR14 1.5V batteries. To install and
replace the batteries, please follow the steps below:
1.
Insert finger or other solid object in the space at the bottom center
of the battery compartment and lift up to remove the cover.
