5
indoor temperature and the time as 12:00 will be displayed. If they are not shown
in LCD after 60 seconds, remove the batteries and wait for at least 60 seconds
before reinserting them. Once the indoor data is displayed user may proceed to
the next step.
3.
After the batteries are inserted, the Weather Station will start receiving data
signal from the sensor. The outdoor temperature and humidity should then be
displayed on the Weather Station. If this does not happen after 2 minutes, the
batteries will need to be removed from both units and reset from step 1 and the
signal reception icon is no longer shown.
A. THERMO-HYGRO SENSOR
1. Remove the
Protective Rain Cover
.
2. Remove the
Battery Cover
.
3. Observing the correct polarity, install
2 “AA” Alkaline Batteries
—make sure they
do not spring free, or start-up problems may occur. Replace the
Battery Cover
.
B. WIRELESS WEATHER STATION
Note:
After the batteries are installed,
DO NOT
press any buttons. This may interfere
with the signals, causing temperatures to register incorrectly.
1. Remove the
Battery Cover
on the back of the Wireless Weather Station.
2. Observing the correct polarity, install
2 “AA” Alkaline Batteries
.
3. Replace
Battery Cover
.
4. Wait 15 minutes before pressing any buttons.
Rain protection
cover
Battery
Cover
Battery
Compartment
Battery
Compartment
Battery
Cover
Sensor signal
reception icon
*
