INITIAL SET UP:
IMPORTANT
:
-
Do Not Mix Old and New Batteries
- Do Not Mix Alkaline, Standard, or Rechargeable Batteries
NOTE
: This temperature station can receive one transmitter only.
First, insert fresh 2x AA, IEC LR6, 1.5V alkaline batteries into the TX43U transmitter, observing the
correct polarity (see marking inside battery compartment). Keep transmitter 5-10 feet from the
temperature station.
Within 30 seconds of powering up the transmitter, insert 2x AAA, IEC LR3, 1.5V batteries into the
Temperature Station, observing the correct polarity (see marking inside battery compartment). Once
the batteries are in place, all segments of the LCD will light up briefly. Following, the indoor
temperature will display. If the indoor temperature does not show in the LCD after 60 seconds,
remove the batteries and wait for at least 60 seconds before reinserting them. Once the indoor data is
displayed, proceed to the next step.
After the batteries are inserted, the Temperature Station will start receiving outdoor temp data from
the transmitter. The outdoor temperature should be displayed on the Temperature station. If this does
not happen after 2 minutes, remove the batteries from both units and start again from the beginning.
In order to ensure sufficient 433 MHz transmission, place the outdoor transmitter a distance of no
more than 100 feet (30 meters) from the Temperature Station and the transmitter.
INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER
The Temperature transmitter uses 2 x AA, IEC LR6, 1.5V batteries. When batteries will
need to be replaced, the low battery icon will appear on the LCD in front of the outdoor
temperature. To install and replace the batteries, please follow the steps below:
1. Remove the battery compartment cover. (Slide to the bottom and then lift straight off).
2. Insert the batteries, observing the correct polarity (see marking).
3. Replace the battery cover to the unit.
NOTE:
When changing batteries in any of the units, all units need to be reset by
following the set up procedures. The transmitter at start-up, assigns a random security
code and this code must be received and stored by the Temperature Station in the first
few minutes of power supplied.
INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE STATION
The Temperature Station uses 2 x AAA, IEC LR3 1.5V batteries. When batteries
need to be replaced, the low battery icon will appear in front of the indoor
temperature.
To install and replace the batteries, please follow the steps below:
1. Remove the battery compartment cover.
2. Insert batteries observing the correct polarity (see marking).
3. Replace battery compartment cover.
LOW BATTERY:
Replace the batteries in all units every 12 months to ensure optimum accuracy of these units. A low
battery icon will display next to the outdoor temperature when the transmitter batteries are low and next to
the indoor temperature then the batteries in the temperature station are low.
