La Crosse Technology WS-7047U, Инструкция по эксплуатации

Страница: 6 / 11

•
with the use of screws
•
using the adhesive tape
A. Mounting with Screws
1. Remove the mounting bracket from the remote temperature sensor.
2. Place the mounting bracket over the desired location. Through the three screw
holes of the bracket, mark the mounting surface with a pencil.
3. Where marked, start the screw holes into mounting surface.
4. Screw mounting bracket onto the mounting surface. Ensure that the screws are
flush with the bracket.
B. Mounting with Adhesive Tape
1. With a nonabrasive solution, clean and dry the back of the mounting bracket and
the mounting surface to ensure a secure hold. The mounting surface should be
smooth and flat.
2. Remove the protective strip from one side of the tape.
3. Adhere the tape to the designated area on the back of the mounting bracket.
4. Remove the protective strip from the other side of the tape.
5. Position the remote temperature sensor in the desired location, ensuring that the
indoor temperature station can receive the signal.
III) The Indoor Weather Station
The indoor weather station can be mounted in two ways:
•
with the table stand
•
 on the wall with the use of a wall hanging screw (not included).
A. Using the Table Stand
The indoor weather station comes with the table stand already mounted. If you wish to
use the table-stand all that is required is to place the indoor weather station in an
appropriate location.
B. Wall Mounting
1. Remove the table stand.
2. To do this, pull down on the stand from the rear and rotate forward.
3. Fix a screw (not included) into the desired wall leaving approximately 3/16 of an
inch (5mm) extended from the wall.
4. Place the indoor temperature station onto the screw using the hanging hole on the
backside.
5. Gently pull the station down to lock the screw into place.
OPERATION OF THE WIRELESS WEATHER STATION
6