Page 7 of 12
The Minutes digits of the Alarm Time will flash. Use the
“
PLUS
” button to set the minutes. You can hold the
"
PLUS
" button in to speed up the setting of minutes by
using five minute increments. Press the "
ALARM
"
button to confirm your minutes setting and to end the
setting procedure.
4. To activate or deactivate the daily alarm:
Briefly press the “
ALARM
” button once. When the
alarm is active the clock displays the alarm icon
below the word "TIME", when the alarm is deactivated,
the alarm icon
will not display.
5. About the Time Alarm:
After 15 seconds without pressing any button the clock
switches automatically from alarm setting mode to
normal clock mode.
The alarm will sound for 85 seconds if not deactivated.
You can deactivate it by pressing any button. The
alarm will be repeated automatically after 24 hours.
The alarm uses 3 different patterns of tone, beginning
gently and increasing in intensity, known as a
"Crescendo Alarm".
Battery Replacement Information
Wireless Display
To replace the batteries in the wireless display:
1.
Lift up the battery compartment cover and remove
the batteries.
2.
Please take note to install the batteries with the
proper polarity as it relates to the battery diagram
inside the battery compartment (+). The batteries
will fit tightly. To avoid start-up problems please
ensure that the batteries do not spring free.
3.
Replace compartment cover.
Please follow the steps listed in the Setup section of
this manual to ensure that the wireless data reception
is successful.
The TX61U-IT Wireless Solar-Powered Sensor
Does Not have replaceable batteries.
The TX61U-IT uses solar power and automatically
charges the internal power cell(s). No battery
replacement is needed.
Help us to keep our environment clean. Please
take any used batteries to an authorized depot
for recycling.