9
D. LED
BACKLIGHT
1.
The projection alarm has an LED backlight designed for night-viewing. This will light
up for 4 seconds whenever the snooze button is pressed.
2.
The LED backlight cannot be turned on constantly; this would drain the batteries.
E. INDOOR
TEMPERATURE
1.
The projection alarm measures indoor temperature with an internal sensor.
2.
This temperature is displayed in
°
F.
3.
The indoor temperature will take time to adjust to the surrounding temperature as the
sensor is inside the case.
F. INDOOR
HUMIDITY
1.
The projection alarm measures indoor humidity with an internal sensor.
2.
This humidity is displayed as a percentage (%).
3.
The indoor humidity will take time to adjust to the surrounding humidity as the sensor
is inside the case.
G. TIME
ALARM
1.
SETTING THE ALARM
a.
Press and hold
“AL/HOUR”
button for three seconds until the alarm time is
flashing.
b. Press
and
release
“AL/HOUR”
to advance the hour, and
“MODE/MIN”
to
advance the minute. The time will display “PM” if set to PM, and nothing if set to
AM.
c.
The projection alarm will revert to normal operation when no buttons are pressed
for 15 seconds. The alarm is now set and activated.
2. ACTIVATING/DEACTIVATING
THE
ALARM
a.
After entering the alarm setting
mode, the alarm is activated.
b.
To toggle between activating
and deactivating the alarm,
press the
“AL/HOUR”
button
briefly. “(((
○
)))”will be displayed
above the time display when the
alarm is activated.
3.
TURNING ALARM OFF (WHILE
SOUNDING)
a.
While the alarm is sounding, press and release the
“SNOOZE”
bar to disable the
alarm for 10 minutes.
b.
After the SNOOZE bar is pressed the alarm icon will flash.
c.
To disable the alarm for 24 hours, press and release any button other than
SNOOZE or display direction buttons.
NOTE: The alarm will sound for 84 seconds if the
“SNOOZE”
button is not pressed.
The alarm speeds up twice, once after 20 seconds and again after 50 seconds.
