La Crosse Technology, Ltd.
Page 13
DATE: The
Date
will flash. Press and release the ▲/DATE or ▼/RAIN button to set the correct Date.
Press and release the SET button to confirm and continue.
FAHRENHEIT/CELSIUS:
°F
will flash in the wind chill, indoor temperature and outdoor temperature
areas. Press and release the ▲/DATE or ▼/RAIN button to select between Fahrenheit and Celsius.
Press and release the SET button to confirm and continue.
WIND SPEED UNIT: Wind Speed unit
MPH
will flash. Press and release the ▲/DATE or ▼/RAIN
button to select from mph, m/s, knots, Beaufort or km/h. Press and release the SET button to confirm
and continue.
RAIN UNIT: Rainfall
Inches
will flash. Press and release the ▲/DATE or ▼/RAIN button to select in
or mm. Press and release the SET button to confirm and continue.
PRESSURE UNIT: The Air Pressure unit
inHg
will flash. Press the ▲/DATE or ▼/RAIN button to
select inHg or hPa. The default setting is inHg. Press and release the SET button to confirm and
continue.
RELATIVE PRESSURE SETTING: The
Relative Air Pressure
will flash. Press the ▲/DATE or
▼/RAIN button to adjust the Relative Air Pressure
.
Press and release the SET button to confirm and
continue.
Note:
Refer to your local weather reporting station for an appropriate setting. It is important that this
setting is adjusted for local conditions to ensure forecast accuracy.
FORECAST SENSITIVITY: The
Forecast Sensitivity
will flash. The default setting of
.09
works well
in most areas of the country, however in areas with relatively constant pressure this should be set to
.06, (within 30 miles of the coast) and in areas with significant pressure changes this should be set to
0.12 (within 30 miles of the desert). Press the ▲/DATE or ▼/RAIN button to adjust. Press and
release the SET button to confirm and continue.
STORM ALARM SENSITIVITY: The
Storm Alarm Sensitivity
will flash. The default setting of
.15
works well in most areas, however you may need to adjust this level up or down depending on your
local conditions. Use the ▲/DATE or ▼/RAIN button to adjust. Press and release the SET button to
confirm and continue.
STORM ALARM: AON or
AOFF
will flash. This will turn the Storm Alarm ON or OFF. Use the
▲/DATE or ▼/RAIN button to toggle the Storm Alarm ON (AON) and OFF (AOFF). Press and
release the SET button to confirm and continue.
WIND DIRECTION DISPLAY: The
Dash
in the wind compass will flash. Use the ▲/DATE or ▼/RAIN
button to select the Wind Direction to show in degrees (dash) or letters NNW. Press and release the
SET button to confirm and continue.
FACTORY RESET:
Res off
will display
. Use the ▲/DATE or ▼/RAIN button to select:
•
Res LO
to reset the Internet connection only (all weather station readings remain unchanged)
Weather station will need to be re-registered.
•
Res ALL
only
if you wish to Factory Reset the Weather Center.
•
Res OFF
When you do not wish to restart the weather center, but were changing settings (time
date etc.).
Press and release the SET button to complete the program menu.
Note:
To Factory Reset the weather center, select
Res ALL
and press the SET button to confirm.
The station will begin to count down numbers in the date area. When it is complete, it will say
done
.
Then remove the batteries and follow the Restart up procedure.
Change display
Modes:
Press and release SET button to toggle between the display of Mode 1 or Mode 2:
Mode 1:
•
Wind Speed
•
24 hr. Pressure History Graph
Mode 2:
•
Wind Gust
•
72 hr. Pressure History Graph
Up Arrow:
•
Press and release to switch between Date and Seconds displayed.
•
Hold until the station beeps to resync with sensors.
Down Arrow:
