La Crosse Technology 616-146v3, Часто задаваемые вопросы

Страница: 12 / 14

La Crosse Technology, Ltd. www.lacrossetechnology.com/support Page 12
Operating on a/c power:
Projection is displayed constantly when operating on A/C power, unless manually shut off.
 Rotate Projection Image: When you place the clock and the projection looks upside
down or sideways, you can rotate the image to make it readable.
 Press and release the PROJECTION button to rotate projection image 90 degrees.
 Press and release the PROJECTION button again to rotate another 90 degrees.

Change Projection Mode: Hold, then release the PROJECTION button to switch
projection modes. You will need to watch the projection image to view the changes.
 Time and Outdoor Temperature: alternate every 5 seconds (default)
 Time : Hold and release PROJECTION button
 Outdoor Temperature: Hold and release PROJECTION button again
 Projection Intensity: The brightness of the projection is adjustable in three settings:
High, Low, and OFF.
 HIGH: The projection is defaulted to HI (brightness) when the A/C adapter is in use.
 LOW: Press and release the SNOOZE/LIGHT button to dim the brightness of the
projection.

Press and release the SNOOZE/LIGHT button to return projection to full strength
(HIGH).
Note:
When the Adapter is NOT in use, the High/Low feature is not available.
Note:
When you adjust the projection, you adjust the backlight at the same time.
Battery Power:
Press and release the SNOOZE/LIGHT button to show the projection for 10
seconds. The projection will not stay on when operation on battery power only.
Daylight Saving Time

Dependent on your location, position of the clock in your home, and atmospheric
interference, it may take up to 5 nights for the change from Daylight Savings Time to
Standard Time and vice-versa to occur.
 Check for a WWVB Tower Icon showing on your Clock. The tower icon indicates you
have received the WWVB signal from Ft Collins CO in the past 24-hours.
 Check that the clock is in the correct Time Zone .
 Check whether the DST indicator is ON or OFF. If the indicator is OFF the clock will not
change.
 Check for fresh batteries . Without proper batteries, the antenna will have a harder
time picking up the signal.
 Position the Atomic Projection Alarm in a window (
with the front or back) facing Ft.
Collins, Colorado and leave for up to five nights. If you do not have a window facing
this direction, locate the Clock near an outside wall and point the unit in this general
direction.