La Crosse Technology, Ltd. www.lacrossetechnology.com/support
Page 2
3.
Verify that the clock is blank before proceeding (there may be lines painted on the
screen that will show when there is no power).
4.
Leave without power for 15 minutes
(very important).
5.
Insert the USB Power Cord into the wall outlet then into the clock.
Clock
Power Requirements
•
A 5-volt USB Power Cord powers this clock.
•
Optional CR2032 backup battery may be used to back up time and date.
Note:
Backup battery will not run the clock display.
12/24-Hour Time Format
•
Use the program menu to select 12 hour or 24 hour time format..
Fahrenheit Temperature display.
•
This clock reads in Fahrenheit only.
Backlight HI-LO-OFF
•
USB Power Cord:
The backlight is on continuously when operating the clock with the
5-volt USB Power Cord.
•
Press the
button to dim the display or to brighten the display. (HI-LOW-OFF)
Backlight Auto Dim
1.
Hold the AUTO DIM SET button until OFF and the Auto Dim Icon shows. Press the +
or DST/- button to turn ON.
2.
Press the AUTO DIM SET button to select the Auto Dim Start Time (10:00pm will
flash). Press the + or DST/- button to adjust.
3.
Press the AUTO DIM SET button to select the Auto Dim Duration from 1Hr to 12Hr
(8Hr will flash). Press the + or DST/- button to adjust.
4.
Press the AUTO DIM SET button to confirm and exit.
When the Auto Dim Icon is displayed, your backlight will automatically dim at the start
time and brighten again at the stop time selected.
Manually Set Time/Date: Program Menu
1. Hold the SET button to enter the Settings Menu.
