La Crosse Technology, Ltd.
Page 3
9. When RF connection is established, the temperature will appear on the station. Allow the
outdoor sensor and wireless thermometer to sit together for 15 minutes to establish a strong
connection.
10. Do not press buttons for 15 minutes.
For optimum 433MHz transmission, place the outdoor sensor no more than 300 feet (91
meters, open air) from the wireless thermometer.
distance/resistance/interference
for details on mounting
the outdoor sensor.
Outdoor Temperature Transmitter
Compatible Outdoor Transmitters
A TX141v2 outdoor transmitter comes packaged with this Digital Atomic Clock.
The TX141 and TX14 (433MHz) transmitters are compatible with this Digital Atomic Clock.
Fahrenheit/Celsius
Digital Atomic Clock
: Press and release the °F/°C button on the back of the Digital Atomic
Clock to switch the temperature display from Fahrenheit to Celsius.
Flashing Outdoor Temperature
The outdoor Temperature reading will flash when the connection is first lost or intermittent
between the Digital Atomic Clock and the outdoor transmitter.
is generally the cause of intermittent connection or loss of connection
between the transmitter and the Digital Atomic Clock.
of the Digital Atomic Clock. Turn the Digital Atomic Clock 90 degrees
towards the outdoor transmitter for better reception.
often resolve the connection issue.
Dashes shown for Outdoor Temperature
Dashes means the connection is lost between the Digital Atomic Clock and the outdoor
transmitter.
can cause loss of connection between the transmitter and the Digital
Atomic Clock.
Reorientation of the Digital Atomic Clock 90 degrees towards the outdoor transmitter may
provide better reception.
Quick Connect
Explanation:
The quick connect is used for a clock and outdoor sensor that have been working but lost
connection due to interference or low batteries. This is not a thorough factory reset.
1.
Bring the outdoor sensor and clock together inside and place the units 5-10 feet apart with nothing
between them.
2.
Hold the
+
button on the wireless thermometer. The outdoor temperature area will flash.
3.
Remove battery cover from the outdoor sensor and press and release the TX button to send the
signal.
4.
Wait for 2 minutes for the outdoor temperature to appear on the clock.
: If the above procedure does not work, please try the factory reset below.
