La Crosse Technology 513-1311OT, Часто задаваемые вопросы

Страница: 5 / 10

La Crosse Technology, Ltd Page 5
Outdoor Temperature Changes Constantly

You may have an additional compatible outdoor sensor within range.

Occasionally a neighbor will have a compatible outdoor sensor that is within range.

During setup, the temperature may change frequently as the clock looks for the sensor.
Outdoor Sensor Drains Batteries Quickly

Test a new set of alkaline batteries. Write down the date of installation and the voltage of the
batteries.

When the batteries fail, please note the date and voltage again. This is helpful in
determining the problem.

Check the distance and resistance between the sensor and clock. Sensors at the end of the
range may work while batteries are fresh but not after they drain a bit.

Check for leaking batteries, which may damage the sensor.

Battery life is over 24 months when using reputable battery brands for both Alkaline and
Lithium batteries.
Mounting/Positioning Outdoor Sensor

Mount outdoor Temperature sensors vertically and under a bit of an overhang.

Protect the outdoor sensor from standing rain or snow, and from the overhead sun, which
can cause it to read incorrectly. Generally, mounting under an eave or deck rail works well.

Construct a small roof or box for the sensor if you do not have an overhang. Please be sure
the box is well vented.

Mount the sensor on the north-side to prevent sun from causing incorrect readings.

Mount at least 6 feet in the air for a strong signal.

Outdoor sensors are water resistant but not water proof.

Avoid more than one wall between the sensor and the clock.

Do not mount near electrical wires, transmitting antennas or other items that will interfere
with the signal.

RF (radio frequency) signals do not travel well through moisture or dirt.

Place the outdoor sensor and the clock in the desired shaded locations, and wait
approximately 1 hour before permanently mounting the sensor to ensure that there is proper
reception.

Do not mount the sensor on a metal fence. This significantly reduces the effective range.
MOUNT

Choose a location for the sensor that is within range of the clock and under an overhang for
accuracy.

Install one mounting screw into a wall leaving approximately ½ inch (12.7mm) extended.

Place the sensor onto the screw, using the hanging hole on the backside.

Gently pull the sensor down to lock the screw into place.
Note: Always ensure that the sensor locks onto the screw before releasing.
Position Digital Atomic Clock
 Mount the clock near an exterior wall with the front or back facing toward Ft. Collins,
Colorado for best WWVB reception.
 The clock should be six feet from other electronics or wireless devices to best receive the
outdoor temperature sensor signal.