La Crosse Technology, Ltd
Page 6
NAP Feature
Sometimes, we just want a quick nap without having to set a new alarm. Set the nap
duration one time, then, a simple press of the NAP button starts the nap countdown.
Set Nap Duration:
1. Hold the NAP button for 3 seconds. NAP and the duration will show (default is 10
minutes).
2. Use the +/- buttons to select a nap duration, up to 120 minutes.
3. Press the NAP button to confirm and start nap count down to zero.
Note: Set NAP once then just press NAP button to activate anytime.
When you wish to nap: Press the NAP button once, and the clock will wake you at the
preselected time.
From normal time display, press the NAP button once to start the nap feature for the
preset time. NAP will show and the preset minutes will countdown.
When the alarm sounds NAP and 00m will flash. The alarm will sound for two minutes
and then stop if no buttons are pressed.
Press any button at any time to exit nap mode.
Alarm Clock is dim
Press and release the SNOOZE/LIGHT button to determine if the backlight is on HIGH
or LOW.
Clock must operate on Power cord for backlight to stay on.
Alarm Clock is blank: No letters, numbers or dashed lines
Check that the Power cord. Is it correctly installed and connects to an active outlet.
may be overpowered or underpowered. Remove batteries from alarm clock.
Press any button 20 times. Leave the alarm clock unpowered for 1-2 hours.
Power clock with Power cord only to determine if batteries were an issue.
Inaccurate Indoor Temperature Reading
Explanation: These symbols are error messages indication the indoor sensor is outside of
its readable range. For indoor readings, this is generally a power related issue.
may be overpowered or underpowered. Remove power from the alarm clock.
Press any button 20 times. Leave the alarm clock unpowered for 1-2 hours.
Install the Power cord or fresh Alkaline batteries with correct polarity.
Dashes, OFL, HH.H, LL.L or Stuck Indoor Temperature
This is generally a power related issue.
Check that the Power cord. Is it correctly installed and connects to an active outlet.
may be overpowered or underpowered. Remove batteries from alarm clock.
Press any button 20 times. Leave the alarm clock unpowered for 1-2 hours.
