3
POSITIONING THE OUTDOOR TEMPERATURE SENSOR
The remote temperature sensor should be mounted vertically to avoid damage.
WALL MOUNT
Install one mounting screw (not included) into a wall within
transmission
range of the weather station, leaving approximately 3/16 of
an inch (5mm) extended from the wall.
Place the transmitter onto the screw, using the hanging
hole on the backside.
Gently pull the transmitter down to lock the screw into
place.
NOTE:
Always ensure that the transmitter locks onto the screw
before releasing.
TABLE STAND
Set the transmitter upright on a table or desk.
NOTE
: This is not recommended as the transmitter may blow over
and be damaged.
To achieve a true temperature reading, avoid mounting where direct sunlight can
reach the outdoor temperature sensor. It is recommended to mount the outdoor
temperature sensor on a North-facing wall or in any well shaded area. The
maximum transmitting range in open air is 200-feet (60 meters) obstacles such as
walls, concrete, and large metal objects can reduce the range.
Place both units in their desired location, and wait approximately 10 minutes before
permanently mounting the sensor to ensure that there is proper reception. The
outdoor temperature sensor is not waterproof and should not be placed anywhere
it will become submerged in water or subject to standing water or snow.
SPECIFICATIONS:
Indoor
:
Temperature Range: 32° F to 122° F (0° C to + 50° C)
Humidity Range:
20%-99% (RH)
Interval:
Every 10 seconds
Outdoor
:
Temperature Range: -20°F to 140°F (-29°C to 60°C)
Humidity Range:
20%-99% (RH)
Distance:
200 ft (60 meters) RF 434MHz (open air)
Interval:
Every 35 seconds
Adapter:
Receiver:
6-volt a/c power adapter (included)
Optional 3-AAA, IEC, LR3 alkaline batteries (not included).
Transmitter:
2-AAA, IEC, LR3 alkaline batteries (not included).
Dimensions:
Receiver:
6.29 ” L x 2.6” W x 4.17 ” H (160 x 66 x 106mm)
Transmitter: 2.55” L x 1.18” W x 3.5” H (65 x 30 x 90mm)
WARRANTY INFORMATION
La Crosse Technology, Ltd provides a 1-year limited warranty on this product
against manufacturing defects in materials and workmanship.
This limited warranty begins on the original date of purchase, is valid only on
products purchased and used in North America and only to the original purchaser
of this product. To receive warranty service, the purchaser must contact La
Crosse Technology, Ltd for problem determination and service procedures.
Warranty service can only be performed by a La Crosse Technology, Ltd
authorized service center. The original dated bill of sale must be presented upon
request as proof of purchase to La Crosse Technology, Ltd or La Crosse
Technology, Ltd’s authorized service center.
La Crosse Technology, Ltd will repair or replace this product, at our option and at
no charge as stipulated herein, with new or reconditioned parts or products if found
to be defective during the limited warranty period specified above. All replaced
parts and products become the property of La Crosse Technology, Ltd and must
be returned to La Crosse Technology, Ltd. Replacement parts and products
assume the remaining original warranty, or ninety (90) days, whichever is longer.
La Crosse Technology, Ltd will pay all expenses for labor and materials for all
repairs covered by this warranty. If necessary repairs are not covered by this
warranty, or if a product is examined which is not in need or repair, you will be
charged for the repairs or examination. The owner must pay any shipping charges
incurred in getting the La Crosse Technology, Ltd product to a La Crosse
Technology, Ltd authorized service center. La Crosse Technology, Ltd will pay
ground return shipping charges to the owner of the product to a USA address only.
The La Crosse Technology, Ltd warranty covers all defects in material and
workmanship with the following specified exceptions: (1) damage caused by
accident, unreasonable use or neglect (including the lack of reasonable and
necessary maintenance); (2) damage occurring during shipment (claims must be
presented to the carrier); (3) damage to, or deterioration of, any accessory or
decorative surface; (4) damage resulting from failure to follow instructions
contained in the owner’s manual; (5) damage resulting from the performance of
repairs or alterations by someone other than an authorized La Crosse Technology,
Ltd authorized service center; (6) units used for other than home use (7)
applications and uses that this product was not intended or (8) the products
inability to receive a signal due to any source of interference.. This warranty
covers only actual defects within the product itself, and does not cover the cost of
installation or removal from a fixed installation, normal set-up or adjustments,
claims based on misrepresentation by the seller or performance variations
resulting from installation-related circumstances.
LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR
INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES
ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT.
THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR
PUBLIC INFORMATION. THIS PRODUCT IS NOT A TOY. KEEP OUT OF
CHILDREN’S REACH.
This warranty gives you specific legal rights. You may also have other rights
specific to the State. Some States do not allow the exclusion of consequential or
incidental damages therefore the above exclusion of limitation may not apply to
you.
For warranty work, technical support, or information contact:
La Crosse Technology, Ltd
2817 Losey Blvd. S.
La Crosse, WI 54601
The complete instruction manual is available at:
www.lacrossetechnology.com/308-805
Le manuel d'instruction complet est disponible sur:
www.lacrossetechnology.com/308-805
El manual de instrucciones completo está disponible en:
www.lacrossetechnology.com/308-805
Contact Support: 1-608-782-1610
Product Registration:
www.lacrossetechnology.com/support/register
This Device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) the device must accept any interference received, including interference that
may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER AUTHORITY
TO OPERATE THE EQUIPMENT
All rights reserved. This handbook must not be reproduced in any form, even in
excerpts, or duplicated or processed using electronic, mechanical or chemical
procedures without written permission of the publisher.
This handbook may contain mistakes and printing errors. The information in this
handbook is regularly checked and corrections made in the next issue. We accept
no liability for technical mistakes or printing errors, or their consequences.
All trademarks and patents are acknowledged.
Printed in China
