La Crosse Technology, Ltd.
Page 6
Note:
When multiple transmitters are in use on different channels, a high and/or low temperature may be
set for each channel.
Set Temperature Alarm Channel 1:
1. Press and release the CH button to select channel 1 (when multiple transmitters in use).
2. Hold the TEMP ALERT button until the
High
Temp Alert
icon
appears and the temperature will
flash. Use the
+ or -
button to select your High Temp alarm value. Press and release the SET button
to move to the Low Temp alarm.
3. The
Low
Temp Alert
icon
will appear and the temperature will flash. Use the
+ or -
button to
select your Low Temp alarm value. Press and release the SET button to confirm and exit to current
temperature.
4. The Temp Alert icon
will show in the outdoor temperature area when a temperature alarm is
active. When the temperature alarm sounds, the Temp Alert icon and the temperature value will flash.
Press any button to silence the alarm temporarily.
Set Temperature Alarm Channels 2 or 3:
Use the CH button to select the channel. Follow steps 2-4
above to set temperature alarms on other channels.
Deactivate Temperature Alarm:
Press and release the TEMP ALERT
button three times to deactivate
all temperature alarms. The alert icons will disappear.
Channels
Explanation:
The forecast station will accommodate up to three remote
. The
channel selection (CH) button on the forecast station allows you to see the temperature in various
locations: outdoors, baby’s room, greenhouse, basement, etc.
Press and release the CH button to view channel 1, 2 or 3 on the display when multiple transmitters
are used.
Note:
You cannot change channels if only one transmitter is connected.
CHANNEL SCROLL: Press and release the CH button until you see a circling arrow appear in the
outdoor data area. The display will automatically rotate through the channels for all connected
transmitters.
Press and release the CH button to lock the display into one channel.
Then view channels individually with a press of the CH button.
Multiple Outdoor Transmitters
To connect multiple remote transmitters to the forecast station:
Remove the battery cover from all the transmitters (leave off for setup).
Set the
first
outdoor transmitter to channel 1 and insert 2 AA batteries.
Set the
second
outdoor transmitter to channel 2 and insert 2 AA batteries.
Set the
third
outdoor transmitter to channel 3 and insert 2 AA batteries.
Press and hold CH button on forecast station for 5-10 seconds.
The forecast station will search for all outdoor transmitters.
Press the TX button on the back of each outdoor transmitter to transmit RF signal.
When RF (radio frequency) connection is established, the respective temperature & humidity of the
selected channels will appear on the main unit.
Allow the transmitters and the forecast station to stay 5-10 feet apart for 15 minutes to establish a
solid connection.
Install the battery covers on each sensor.
After 15 minutes, place the remote transmitters in appropriate locations within range of the display.
Press and release the CH button to view channel 1, 2 or 3 on the display when multiple transmitters
are used.
