L3 Narda SignalShark 3320, Быстрый старт

Страница: 29 / 84

Narda SignalShark 3320 Remote Unit 29
EN
6 Installing connections
6.1 Power supply
The SignalShark 3320 is operated via an AC/DC adapter.

Connect the AC/DC adapter to the DC power input of the
SignalShark 3320. If you use a screw connection, you must screw the
cable connector to the power input to ensure a reliable power supply.

The device starts automatically when connected to the power supply.
6.2 Connecting RF connectors
Use the RF inputs (three RF SMA one RF N input) located on the
back of the SignalShark 3320 to connect RF connectors.
When using an RF SMA input:

Connect the SMA plug to the SMA socket (see Figure 2: caption 1) and
carefully tighten the SMA connection with a torque wrench.
6.3 Installing the Narda automatic DF antennas
The SignalShark 3320 is intended for use with the automatic DF antennas.
For the use of other Narda antennas as well as cables and antennas from
other manufacturers, refer to the operation manual. The operation manual
can be found on the USB device or in the SignalShark online help (for
details on how to access the online help, refer to
Operating via the graphical
user interface (GUI) on page 34).
A detailed procedure on how to replace the RF cable on the Automatic DF
Antenna can be found in the
Narda Automatic DF Antenna Handling and
Safety Instructions (3360/98.12).
NOTICE
Exceeding the maximum torque
The SMA connection may be damaged, when exceeding the
maximum torque.

Do not exceed the maximum torque of 0.6 Nm.

Do not tilt and turn the cable while screwing.