L2 Audio PH-1023, Руководство пользователя и инструкция по эксплуатации

Страница: 6 / 8

26. Rec out. This output can be connected to the input(s) on any recording device.
27. Output
(main/monitor) These outputs enable you to send line level signals to an external
input source.
28. Amp mode.
This is to alter the amp mode. BRIDGE MODE bridges the 2 internal amps
together to give you 1 x 400, 600 or 1000 watt mono output. (see bridge output). MONO 1
+ 2/MON splits the 2 amplifiers to enable you to use one for the out front mix and one for
the stage monitors. CH 1 + 2 is considered to be ‘normal mode’, giving you 2 x 200/300/500
watts to your out front mix.
29. AC Power connector. This is where the mains IEC plugs in. It also houses the internal AC
power fuse.
30. Main switch. This is to switch the mixer on.
31. Speakers. These are outputs for the speaker leads. Connection is via speakon® or speakcore
connection . The left and right outputs are for normal application when using either 2 x
separate amplifiers for out front mix configuration (1 to the left speaker, 1 to the right
speaker) or Main/mon configuration when the left hand output goes to the fold back
monitor and the right hand output goes to the out front speaker. NB. You can then link in
another speaker from the speaker output, providing the total speaker load does not go
below 4 ohms. All L2 audio speakers are 8 ohms each, so linking two together will send the
total load down to 4 ohms. This is OK. DO NOT CONNECT 2 x 4 OHM SPEAKERS TOGETHER
IN THIS WAY OR THE AMPLIFIER WILL OVERHEAT AND SERIOUS DAMAGE COULD OCCUR . If
you are using the mixer in bridge mode the BRIDGE speaker output should be used.
32. Fan. Designed to keep the amplifier cool. Please do not obstruct.