STEP 5
Attach drawer (D) hardware as
shown at right. Repeat to other side
of drawer, so all 4 pulls are attached.
STEP 6
Place Drawer (D) onto the frame
assembly resting on the stretchers.
Lift one side of drawer up and place
shuttle block into groove on drawer
side. Make sure the 1” width of
block is in the groove. Carefully set
drawer back onto the frame so
shuttle block is resting on the cleat
attached inside the side assembly
(A). Repeat to other side of drawer.
Note: the shuttle blocks will act as a
drawer stop when pulling the drawer
out from either side.
STEP 7
Lay top (E) upside down on a
protective area and using (2) 3/8”
screws attach each bracket to the top
aligning the bracket over the
predrilled holes. Note: make sure
the single hole tab of bracket is
placed to the outside edge on each
side. Repeat for each of the four
brackets.
