QUESTIONS:
Should you have any questions during the final assembly of your new bicycle, please call our product 11/12/13
specialists at 800-226-7552 any day between 8:00 a.m. and 10:00 p.m. Eastern. pg.
3
2. FRONT WHEEL INSTALLATION
The brake cable on rim brakes should be disconnected (2-A). If it is connected (2-B), disconnect by holding the brake
arms together and removing the silver insert from the cable stop.
To reconnect after wheel is on, hold the brake arms together and place the silver insert into the cable stop as shown (2-B)
or as seen on the rear brake of your bike.
To install the quick-release front wheel:
Remove the quick-release front skewer (2-C) from the parts box. Align the tread direction of the front tire with that of the
rear. Unscrew the lock nut (2-D) from the quick release skewer, remove the outer spring and slide the skewer through the
front wheel axle. Install spring and start to thread lock nut, but do not tighten. There should be a spring on each end of the
wheel axle. Both springs should have the smaller ends facing the wheel axle (2-D)
Silver insert
Cable stop
Silver insert
connected to
cable stop
Disconnected
brake cable
Properly
connected
brake cable
2-A
2-B
Brake arms
Correctly installed skewer
– in open position
Note
direction
of springs
Front skewer
2-C
2-D
Lock nut
Quick-release
lever