IP-00002 Rev. C – 04/05 Page 2/3
Copyright © This drawing is property of L-com Global Connectivity. All rights reserved.
Determine the polarity which will be chosen
for the antenna installation. The antenna can
be installed either vertically or horizontally
polarized.
The two polarities are illustrated below:
Horizontal
Polarity
Vertical
Polarity
Position the “L” Bracket to the back of the Grid Assembly,
noting the orientation required for the desired polarity.
Position the Feedhorn to the front of the Grid Assembly,
again noting the orientation required for the desired polarity.
Secure the Feedhorn & “L” Bracket to the Grid Assembly
using (4) #M6 machine screws with lock washers, flat
washers and nuts.
HyperGain™ HG2424G Installation Instructions
Feedhorn
Grid Assembly
“L” Bracket
Install the (2) Mast Clamps on the U-Bolts as shown
and fasten to the “L” Bracket using (4) lock washers
and (4) Nuts.
To mount antenna assembly in a tilted position,
attach (1) U-Bolt assembly to either the fixed tilt
positions or to the tilt slot (as shown) on the
“L” Bracket.
U-Bolts
Mast Clamps
“L” Bracket
Mast
Tilt Slot
Fixed Tilt Positions
OPTIONAL TILTED MOUNTING
Important Note: Feed Reflector must be orientated to
grid as shown for optimal antenna performance.
Feed Reflector
L-COM, INC. 45 BEECHWOOD DRIVE NORTH ANDOVER, MA 01845
WWW.L-COM.COM E-MAIL: [email protected] PHONE: 1-800-343-1455 FAX: 1-978-689-9484
© L-com, Inc. All Rights Reserved. L-com Global Connectivity and the L-com logo are registered marks.
