![background image](http://html1.mh-extra.com/html/l-b-white/director-cp100aki/director-cp100aki_owners-manual-and-instructions_664877009.webp)
To connect a thermostat refer to the following instructions:
a) Pull latch away from thermostat plug on control
panel.
b) Disassemble the plug.
c) Remove jumper at terminals 2 and 3. See Fig. 5.
(Keep the jumper. The jumper may be reinstalled
if manual operation of the heater is desired later.)
d) Remove plastic cap within strain relief.
e) Route thermostat cord set through strain relief,
support rings, and into plug. Thread strain relief
into plug housing.
f) Connect black and white wires to terminals 2
and 3, and green wire to ground terminal.
See Fig. 5.
g) Assemble thermostat plug and connect to control
panel.
CONNECTING THERMOSTAT
(Optional Accessory - Part #24219)
14
9
STRAIN RELIEF NUT
CAP (DISCARD TO ADD THERMOSTAT WIRING)
PLUG HOUSING
BLACK
REMOVE JUMPER WIRE
IN TERMINAL 2 AND 3
PLUG
SCREW
THERMOSTAT WIRE
GREEN
WHITE
SUPPORT RINGS
FIG. 5
LOOSEN SCREWS TO
ADD THERMOSTAT WIRING
REAR SCREW SIDE
FRONT PIN SIDE
2 1
3
2
1
3
REAR SCREW SIDE
FRONT PIN SIDE
Содержание Director CP100AKI
Страница 16: ...Parts Identification 16 PARTS SCHEMATIC ...