L-Acoustics LA-RAK, Руководство пользователя

Страница: 135 / 201

Rigging procedures
12.
Close the four KARA#1 arms as follows (repeat on both sides of the enclosure):
a) Remove the front top R-BLP from its link hole, slide the front arm up, rotate it down, and lock it in place by re-
inserting the R-BLP into its storage hole.
The front top
storage
and
link
holes are the same.
b) Remove the rear top R-BLP from its angle hole, slide the angle arm so as to align the cursor with the storage label,
and lock it in place by re-inserting the R-BLP into its
storage
hole.
13. Attach the lid to the ight-case.
14.
Remove the top SB18 (SB18#2 for example) from the SB18 below (SB18#1 for example) as follows:
a) Remove a top T-BLP from SB18#1.
b) Rotate the link arm up.
c) Lock the link arm in closed position by re-inserting the T-BLP into SB18#2.
d) Repeat this procedure until all four arms are locked in closed position.
15.
Attach a dolly board to SB18#2 and remove SB18#2 from the rigging location.
16. Repeat steps 14 (p.135) and 15 (p.135) until all SB18 of the array are disassembled.
Kara owner's manual (EN) version 1.0 135