Corrective maintenance
4.
Pierce the label and carefully remove the center screw while holding the cone in place.
Use the 3 mm hex bit.
Discard the paper disk to avoid parasitic vibrations.
5.
Remove the cone.
6.
Carefully remove the diaphragm holding it by the connectors.
7.
If there are black spacers on the air gap, do not remove them.
Reassembly
About this task
For safety reasons, always use the new screws and spare parts provided in the KR.
Procedure
1.
Clean the driver and the air gap.
Use a blower or double face adhesive tape to clean any particle.
Make sure the air gap is perfectly clean before moving to the next step.
2.
Carefully place the diaphragm.
If there are black spacers, make sure they remain in place.
3.
Position the diaphragm using the screw holes as reference points.
The connectors must be positioned halfway between two screw holes.
4.
Place the cone in the middle.
5.
While holding the cone in place, manually drive the center screw using the 3 mm hex wrench.
6.
Secure the cover with the four SDT00447 provided in the KR.
a) Gradually secure by hand each screw with the 3 mm hex wrench.
Follow a star pattern.
b) Tighten the screws in the same order with the torque screwdriver.
Use the 3 mm hex bit. Set the torque to 1.7 Nm.
7.
While holding the cone in place, tighten the center screw with the torque screwdriver.
Use the 3 mm hex bit. Set the torque to 1.7 Nm.
8.
Carefully position the HF loudspeaker on the LF loudspeaker.
Use the connectors as reference points. When facing the HF loudspeaker connectors, the small connector must be on
the left, and the larger one on the right.
9.
Secure the HF loudspeaker on the LF loudspeaker with the two SDT00448 provided in the KR.
Use the 4 mm hex bit. Set the torque to 3 Nm.
38
5XT owner's manual (EN) version 4.0
Содержание 5XT series
Страница 1: ...5XT owner s manual EN ...
