Model
SHUFFLE KW
Manufacturer
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
11/20
N° DOC
UM000495
15. PUTTING INTO OPERATION
If the cabinet has been sharply tilted while being sited or for mounting of accessories, it must be left to stand for
at least three hours before being started to allow the lubricating oil to settle in the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR WILL HAVE TO BE
CONNECTED IS TO BE PROTECTED BY A VERY SENSITIVE DIFFERENTIAL SWITCH
(Rc=16A,Dc=30mA); IT IS ALSO TO BE LINKED TO THE GENERAL EARTHING PLANT.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords, adapters or multiple socket outlets
to connect the counter.
DIRECTLY connect the equipment to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught or stepped on,
away from water and the other liquids and heat sources and must not be damaged.
In case of breakage of the power cable of the cabinet, it must be replaced by the manufacturer or by
instruction it change of it.
Follow the manufacturer’s instructions to install the unit, using qualified personnel and complying with the electrical
regulations for the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or things due to incorrect
observance of this rule.
16. ENERGY SAVING TIPS
•
Install the appliance in a dry, well-ventilated room away from heat sources (radiator, cooking surface
and so on) and in a position out of direct sunlight.
•
Follow the installation instructions to ensure adequate ventilation. Insufficient ventilation to the back of
the appliance causes an increase in energy consumption and reduces cooling efficiency.
• The internal temperature of the appliance depends on the room temperature, how often the doors are
opened and where the appliance is placed. These factors have to be taken into account when setting the
thermostat. Only open the doors when strictly necessary.
•
Let hot food and drink cool down before placing them in the appliance.
•
The positioning of the shelves in the fridge has no effect on energy efficiency.
•
The fridge compartment light system uses a LED light, which at the same time ensures more efficient
lighting and reduced energy consumption.
17. OUTER CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING THE POWER
PLUG BEFORE CLEANING.
For a good preservation of the cabinet’s body a periodical cleaning is necessary.
1. EXTERNAL BODY:
When necessary, the external body should be cleaned with a cloth and a neutral soap and
water solution.
Use also mop for cleaning under the unit and vacuum cleaner for removing dirt or dust.
2. STAINLESS STEEL SURFACES:
Wash with warm water and mild detergent, rinse well and dry with soft cloth.
Avoid scouring pads etc. which will spoil the finish of the stainless steel.
3. SURFACES IN PLASTIC MATERIAL:
Wash with warm water and mild detergent, rinse well and dry with soft
cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
4.
GLASS SURFACES:
Only use products specifically designed for glass cleaning; It is not advisable to use
ordinary water which can leave a film of calcium on the surface of the glass.
