Kyocera FS-1050 - B/W Laser Printer, Руководство по установке

Страница: 17 / 32

15
Turning the Power Switch On
This section describes the procedure for turning on the printer’s power.
During start-up, the language for the message display and status page of this printer
can be selected from English, French, German, Italian, Spanish, and Portuguese.
The default message language is English. For how to change the message lan-
guage to another, refer to the Selecting a Message Language section.
1
Switch on the printer’s power. The mes-
sage display should indicate
Self
test
.
If the indicator does not light,
check that previous steps were
performed properly.
When the printer is first switched
on after installation, there will be a
delay of approximately 15 minutes
before the printer gets ready to
print as the developer unit needs to
be filled with toner. During this
period, the message display shows
Please wait
(
Adding toner
).
2
Wait until the
READY
indicator is also
lit and the message display indicates
Ready
. The printer is ready to print.
Selecting a Message Language
The default message language is English. To change the message language to
another, follow the procedure described below. If required, your dealer can down-
load major languages other than English, French, German, Italian, Spanish, and
Portuguese to your printer. Please contact your dealer.
1
While pressing the
ENTER
key, turn the
power switch ON (
l
). Keep pressing the
ENTER
key until the message display
indicates
Please wait
(approximately
1 minute). The message display should
indicate
Self test
.
2
When the message display shows
Please wait
, release the
ENTER
key.
STEP
8
Ready
--- A4 PLAIN
MENU ENTER
Please wait