(Page.2/4)
Service Bulletin
Ref. No.
2T6-0019 (J010)
<Date> January 25, 2019
KYOCERA Document Solutions Inc.
For authorized KYOCERA engineers only.
Do not distribute to non-authorized parties.
CONFIDENTIAL
A
B
C
Type
Program No.
VER.
Remark
CONTROLLER
2T6_S000.002.028
002.028
Except KDHK
ENGINE
2T6_1000.
002.005
->2T6_1000.
002.006
002.006
New
Upgrade
LANGUAGE BR
2T6_81BR.001.019
001.019
KDA/KDAU/PHILIPPINES & *1
DK
2T6_81DK.001.019
001.019
*1 Danish
NO
2T6_81NO.001.019
001.019
*1 Norwegian
SE
2T6_81SE.001.019
001.019
*1 Swedish
TR
2T6_81TR.001.020
001.020
*1 Turkish
LANGUAGE TW
2T6_81TW.001.009
001.009
AX Asian model/KDTW
CN
2T6_81CN.001.009
001.009
KDCN
KR
2T6_81KR.001.009
001.009
KDKR
For the person who has assigned as a responsibility to access in this new site, it will be possible to download from New Cabi-
Net site (
).
When upgrading firmware or replacing PWB, etc., please upgrade each firmware (MAIN, ENGINE, MMI, etc.) to the latest
version at the same time.
*1: Pre-installed for KDE/TA/OLIVETTI
Field Measure:
Use 002.006 version ENGINE firmware at setup, etc. In case
“Toner Low” is displayed after
upgrading the firmware of the field machine to the new version, replace with the new toner
container. (Refer to above A) for details)
First implemented timing at factory:
January 2019 production
N00105917/N00106073
Firmware upgrade procedure
In case of setup, next user visit or occurring this phenomenon, upgrade the firmware according to either of the
procedures 1-3 below
1.
New machine (Main unit where no power is turned on yet
)
(1)
Unpack and install it before turning the power switch on. (Refer to the service manual [1-2-2 Unpacking
and installation])
*Howeber, do not attach the waste toner box and do not connect the power cord to the outlet.
(2)
Insert a USB drive with the new firmware into the USB host interface slot while the power cord is
disconnected. Connect the power cord to the outlet.
(3)
Turn the power on without the waste toner box
⇒
Firmware update is executed for about 1 minute.
(4)
After confirming the display [FW-Update Completed] (after firmware update is completed), confirm
ENGINEfirmware version is new and [2T6_1000.002.006].
(5)
Turn the power switch off, disconnect the power cord and remove the USB drive.
(6)
Connect the power cord to the outlet and turn the power switch on.
(7)
Confirm [The waste toner box is not properly installed.] or [Select Language] display appears on the
message disply (LCD).
(8)
If necessary, repack the main unit. (Reverse procedure of the service manual [1-2-2 Unpacking and
installation) Or attach the waste toner box, connect the power cord to the outlet to continue the installation
(aftr turning the power switch on).
2.
Field machine 1 (Main unit operating normally)
(1)
Insert a USB drive with the new firmware into the USB host interface slot while the power cord is
disconnected. Connect the power cord to the outlet.
(2)
Turn the power on without the waste toner box
⇒
Firmware update is executed for about 1 minute.
