Kyocera DISCOVER FS-3830N, Руководство по установке

Страница: 20 / 36

18
Turning the Power Switch On
This section describes the procedure for turning on the printer’s power.
During start-up, the language for the message display and status page of this printer
can be selected from English, French, German, Italian, Dutch, Spanish, and Portu-
guese.
The default message language is English. For how to change the message lan-
guage to another, refer to the Selecting a Message Language section.
1
Switch on the printer’s power. The mes-
sage display should indicate
Self
test
.
If the indicator does not light,
check that previous steps were
performed properly.
When the printer is first switched
on after installation, there will be a
delay of approximately 8 minutes
before the printer gets ready to
print as the developer unit needs to
be filled with toner. During this
period, the message display shows
Please wait (Adding toner)
.
2
Wait until the
READY
( ) indicator is
also lit and the message display indi-
cates
Ready
. The printer is ready to
print.
Selecting a Message Language
The default message language is English. To change the message language to
another, follow the procedure described below. If required, your dealer can down-
load major languages other than English, French, German, Italian, Dutch, Span-
ish, and Portuguese to your printer. Please contact your dealer.
1
While pressing the
ENTER
key, turn the
power switch ON (
l
). Keep pressing the
ENTER
key until the message display
indicates
Please wait
(approximately
1 minute). The message display should
indicate
Self test
.
2
When the message display shows
Please wait
, release the
ENTER
key.
STEP
8
Power Switch
Ready
--- A4 PLAIN
GO
CANCEL MENU ENTER
?
Please wait
FS3830NIG.book 18 ページ ２００３年１２月１２日 金曜日 午前１０時０分