72
GENERAL MAINTENANCE
PROTECTIVE RUBBER BOOTS
The protective boots over the ATV's drive shafts and steer-
ing should be inspected periodically.
Ball Joint Boots & Tie Rod Boots
1. Secure your ATV on sturdy stand to elevate the front wheels
2. Remove both front wheels
3. Inspect the four ball joint boots for cracks, tears, or perforations
4. Check the ball joint for free-play by grasping the steering knuckle
and turning it from side to side, and up and down.
5. Inspect the four tie rod boots for cracks, tears, or perforations.
4. Reinstall the wheel and tighten the lug nuts to 40 ft-lb.
3. If the thickness of the pads is less than 1.0 mm (0.039 in.), take
your ATV to a KYMCO ATV dealer to have brake pads replaced
Brake Hoses
Carefully inspect the hydraulic brake hoses for cracks or other
damage. If found, take the ATV to an authorized KYMCO ATV
dealer to have the brake hoses replaced.
Brake Pads
The clearance between the brake pads and brake discs is ad-
justed automatically as the pads wear. The only maintenance that
is required is to replace brake pads when they become worn. To
check the thickness of the brake pads use this procedure:
1. Remove a front wheel
2. Measure the thickness of each brake pad
NOTE: Take your ATV to an authorized KYMCO ATV
dealer for any brake pad replacement service.
Содержание MAXXER 375
