12
. FRONT WHEEL/FRONT BRAKE/
FRONT SUSPENSION
12-10
HYDRAULIC BRAKE (FRONT
BRAKE)
BRAKE FLUID REPLACEMENT/AIR
BLEEDING
Check the brake fluid level on level ground.
BRAKE FLUID BLEEDING
In order to avoid spilling brake fluid, connect
a transparent hose to the bleed valve.
Fully apply the brake lever and then loosen
the brake caliper bleed valve to drain the
brake fluid until there is no air bubbles in the
brake fluid. Then, tighten the bleed valve.
Repeat these steps until the brake system is
free of air.
BRAKE FLUID REFILLING
Add DOT-3 brake fluid to the brake
reservoir.
Make sure to bleed air from the brake system.
BRAKE PAD/DISK REPLACEMENT
Remove the two bolts attaching the brake
caliper.
Remove the brake caliper.
Remove the brake pad pin to remove the
brake pads.
•
When operating the brake lever, the
brake reservoir cap must be tightened
securely to avoid splash of brake fluid.
•
When servicing the brake system, use
shop towels to cover plastic parts and
coated surfaces to avoid damage caused
by splash of brake fluid.
*
Spilled brake fluid on brake pads or brake
disk reduces stopping power. Clean the
brake pads and brake disk with a high-
performance brake degreaser.
Warning
•
When bleeding, be careful not to allow
air in the brake reservoir flowing into
the brake system.
•
When using a brake bleeder, follow the
manufacturer‘s instructions.
•
Never use dirty or unspecified brake
fluid or mix different brake fluids be-
cause it will damage the brake system.
*
The brake pads must be replaced as a set
to ensure the balance of the brake disk.
*
Bleed Valve
Front Brake Caliper
Brake Pad Pins
Upper Limit
Lower Limit
Front Brake Caliper
Содержание 125 MOVIE S INJECTION
