12
Table 6 Pin Definitions of 5-Pin 5.08mm-Spacing Plug-in Terminal Block
Table 7 Wiring and Mounting Specifications
●
Wiring and Mounting
Step 1: Ground the device properly according to section 4.4.
Step 2: Remove the power terminal block from the switch.
Step 3: Insert the power cable into the power terminal block according to Table
6 to fix the power cable.
Step 4: Insert the terminal with the connected cable into the terminal block on
the device.
Step 5: Connect one end of the power cable to an external power supply
system (with the allowed power range). If the power LED on the front panel of
the switch turns on, the power supply is connected properly.
Wiring and mounting should meet following specifications.
Caution:
●
●
Do not touch any exposed conducting wire, terminal, or component
with a voltage warning sign, because it may cause personal injury.
Do not remove any part or plug in or out any connector when the
device is powered on.
●
●
Before connecting the device to power supply, make sure that the
power input meets the power requirement. If connected to an
incorrect power input, the device may be damaged.
To comply with UL restrictions, this equipment must be powered
from a source compliant with Class 2.
Warning: