21
7. Daily cleaning and maintenance
PARTS
Store
Timing of cleaning
Cleaning way
Battery
Do not store in the environment of high
temperature, humidity or sun exposure and every
2 months to replenish electricity, prevention of
over-discharge of the battery
Serious amount of ash
Clean the surface with a soft cloth
Kwun
Turn off the power, and do not store in high
temperature, humidity or sun exposure
About 50 minutes of
interval work or
serious ash
Ultrasonic
sensor
It is strictly forbidden to be squeezed by external
forces
1. Use a damp cloth to clean the cloth.
2. Wipe clean with a dry towel.
Roller brush
Do not store in high temperature, humidity or sun
exposure
Rinse deeply clean with water or comb up and
down with a soft cloth before blowing.
Crawler belt
1. Place the wet rag on a flat surface.
2. Enter remote control mode through APP to
move the device to drive the track cleaning.
1. Prepare the replacement track and spring pliers, and prop up the kwun body to lift the track off the ground, Take out self cleaning stuff.
2. Remove the shaft retaining ring (spring) of the driving wheel and the driven wheel using spring pliers, and remove the outer retaining ring on
the driving wheel and the driven wheel.
3. Reach into the inside of the track and take it out from the inside out to complete the track disassembly.
4. Use the caterpillar to be replaced and install the caterpillar.
5. Put the track into the driving wheel, the slave wheel and the synchronous wheel in turn, and then press the track into the inner retaining ring
of the driving wheel with force, Insert self cleaning stuff.
6. Install the outer retaining ring to the driving wheel and the driven wheel, and use the spring pliers to set the spring in the spring groove of the
driven wheel and the driving wheel respectively.
7. Check to ensure that all driving wheels and external retaining rings of driven wheels are inside the spring grooves to complete installation.
6.1 Track installation and replacement
6. Replacement of common accessories
