KWM Gutterman 6" IROMAN, Руководство по эксплуатации и техническому обслуживанию

Страница: 43 / 46

42
SECTION: 24
6” to 5” COMBO CHANGE OVER CHECKLIST
1. ___ UNPLUG MACHINE:
Eliminate electrical power source.
2. ___ REMOVE COVERS:
Remove covers containing quick-release fasteners.
3. ___ REMOVE GUILLOTINE:
Remove 6” guillotine from machine.
4. ___ REMOVE BACK BELL ROLLER:
Remove from 6” position, and set it to the side.
5. ___ FLIP TOP #3 EXIT DRIVE ROLLER:
Remove & reinstall top #3 back drive roller in 5” position.
Turn roller end-for-end and reinstall using same 82-degree cap screws.
6. ___ INSTALL BACK BELL WHEEL:
Install back bell wheel in the 5” position.
7. ___ MOVE BEAD ROLLER ASSEMBLY:
Loosen and slide bead roller assembly into 5” position
8. ___ INSTALL 5” GUILLOTINE:
Install 5” guillotine on machine.
9. ___ SECURE 6” GUILLOTINE:
Place the 6” guillotine back into storage position.
10. ___ MOVE SKATE ROLLERS:
Pull retractable pins on skate rollers and move inward to 5” position.
11. ___ MOVE BACK GUIDE ROD:
Loosen guide rod bolts, and slide guide rod inward to 5” position.
12. ___ MOVE ENTRANCE GUIDES:
Loosen cap screw on both entrance guides, and move inward to stop at 5” position.
13. ___ MOVE FACE BOX ROLLERS:
Pull retractable pins and lower face box roller to 5” position.
14. ___ REMOVE 6” INSIDE ROLLER BAR FROM LIP BOX:
Remove red colored screws, remove roller bar and set to the side.
15. ___ INSTALL 5” INSIDE ROLLER BAR ASSEMBLY.
Remove 5” roller bar from storage position and install in lip box.
16. ___ STORE 6” INSIDE ROLLER BAR:
Secure 6” inside roller bar in storage position.
17. ___ MOVE LIP BOX BOTTOM ROLLERS:
Pull retractable pins and raise bottom half of the outside lip box roller to 5” position.
18. ___ MOVE COMPLETE LIP BOX:
Loosen mounting bolts and move lip box down and in to the 5” position.
19. ___ REINSTALL COVERS:
Refasten covers and lids to machine.
20. ___ MOVE COIL SPOOL HALVES:
Position spool halves for 11-3/4” or 12” coil.
21. ___ MOVE UPRIGHT ASSEMBLY:
Move upright assembly to the 5” position.