PAGE 3
Using the Wireless Range Extender
1. Adding a Wireless Range Extender to a Sensor Network
KWJ-WSN wireless range extenders can be added to any KWJ-WSN
sensor network through the KWJ-WSN online sensor monitoring soft-
ware.
Steps to add Wireless Range Extenders to your Sensor Network.
•
Choose “Manage” from the main navigation.
• Select the network you would like to add the range extenders to.
•
Find the bottom of the section “Sensor List / Assign Sensor”.
•
Enter the ID and Security Code from the back label of the
range extender.
•
Press the “Assign Sensor” button.
• Repeat this process to add more range extenders to the network.
Once the range extender has been added to your network, you will need
to update and push the sensor device list to your range extender so it
knows what sensors to allow communication with. For a USB gateway,
go to the KWJ-WSN gateway application/service and click “Download
Sensor Updates”. For an Ethernet gateway, power cycle the device by
unplugging it, waiting 10 seconds then plugging it back in. For a
Cellular gateway, use the power button to turn it off, wait 10 seconds
then turn it back on.
After resetting the gateway, plug the range extender into an AC wall
outlet. The range extender will have a green light when it has found the
network. If the light is steady red, check the network, unplug it and try
again.
Contains FCC ID: ZTL-RFSC1
and IC: 9794A-RFSC1
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful
interference and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
ID: ######
Code: XXXXXX
