Add the lock to your smart home system
Re-key the lock (if needed)
6
7
8
3 / 4
Perform the door handing process
This step will teach the lock the orientation of your door and is crucial for lock operation.
A
B
C
D
Install 4 AA batteries
in the battery pack.
Ensure correct polarity.
For best results, use new,
non-rechargeable Alkaline
batteries only.
Make sure the door is open. Insert the battery
pack while
PRESSING AND HOLDING
the
Program button. Release the button when the
battery pack is all the way inside the lock interior.
The Status LED will flash red
and green, and the lock will
beep.
Press and release the
Program button again.
The latch bolt will retract and extend on its
own to learn the orientation of the door. Did
the Status LED turn green or red?
If the bolt does not move, make sure
the batteries are installed correctly,
and perform steps 6A-6D again.
status LED
Metal
contacts
at bottom,
facing out.
Green:
Door handing
successful. Continue
to step 7.
Red:
Make sure the
batteries are installed
correctly and the lock
interior is correctly
installed. Perform
steps 6A-6D again.
H
G
G
A
B
C
IMPORTANT: Remove battery
pack before re-keying.
G
actual
size
window
If you wish to unlock
the window, you can
slide it up for more
convenient access
to the programming
buttons while the
cover is installed.
To unlock the
window, remove
the security screw.
The window
on the interior
cover is locked
by default to
prevent someone
from tampering
with your lock's
settings.
Important Information about the interior cover:
Cover Installation:
Install cover.
Note: You may need to
rotate the turnpiece to align
with the turnpiece shaft.
turnpiece
shaft
turnpiece
Install screws
from Kit “A.”
a
b
E
E
(x3)
Install the interior cover
9
Note: The interior cover
(F) and screws (E)
must be removed for
battery pack access.
F
F
F
F
Initiate the process to add the
lock to your system at your smart
home controller. Refer to your
smart home system instructions
for more information.
When prompted by your smart home system to add the
lock, press button “A” on the lock interior four times.
If successful, re-name the lock in your system (if applicable).
If unsuccessful, press button “B” nine times.
Perform steps 7A-7C again.
If still unsuccessful, follow your smart home system's
instructions to remove (exclude/unpair) the lock from
any other network. Then perform steps 7A-7C again.
A
B
C
D
Re-key the lock to work with your existing
key. See the supplied SmartKey Re-key
instructions for more information.
Reinstall battery pack.
button “A”
button “B”
G
N
