Level Best Operation Guide
Page 7
Control Panel Jumper Instructions
To be used in the event of a control failure.
1. Remove the control panel from the bezel and disconnect the wire harness.
(See
Figure 2
.)
2. Make sure the area around and below the motorhome is clear of all obstructions
and that no personnel are under the vehicle.
3. Plug the large connector of the jumper assembly into the wire harness (Figure 3.)
4. Plug the 4-way connector into the wire harness.
CAUTION: Pump will start
immediately and the jacks will begin to retract.
(See
Figure 3.
)
5. After jacks have been fully retracted, immediately disconnect the 4-way connector
on the jumper assembly from the wire harness to shut off the pump (
Figure 3.
)
Failure to immediately remove the 4-way connector can cause over-heating
of the pump motor and permanent damage to the system.
6. Remove the large connector of the jumper assembly from the wire harness.
7. Have jack system serviced at a qualified service center prior to using the jack
system.
Figure 2: Disconnect the wire
harness from the back of the
control panel.
Figure 3: Attach the Jumper Assembly to the Wire Harness.
NOTE: Immediately disconnect the 4-way connector after the jacks are fully
retracted. Failure to immediately remove the 4-way connector can cause
over-heating of the pump motor and permanent damage to the system.
4-WAY
CONNECTOR
JUMPER
ASSEMBLY
WIRE
HARNESS
CONTROL
PANEL
WIRE
HARNESS
