ASSEMBLING PICTURES
SAFETY RULES
PERFORMANCE
Instruct the person working at the machine how to operate it.
Take care that not more than one person is working at the same machine simultaneously.
The knife lever is moved down with both hands.
After each cutting operation the knife lever is moved back to the starting position until
the knife is locked.
Do not disassemble the front safety guard.
Do not grasp underneath the knife edge.
When changing the knife, strictly adhere to the instructions and use knife holders.
You can cut many varieties of paper and light cardboard
cutting length cutting height capacity/80 g/m
2
paper)
3947
430mm 20mm 200 sheets
* Please be sure that the paper is free of metal parts such as clips and staples.
9
2
1
6
4
5
2
3
10
12
13
8
9
11
12. Insert knife holders into second and fourth
threaden hole and of the sharp
knife. Place knife into knife carrier and
fasten them securely with knife holders.
13. Put the knife lever downwards to be horizontal.
14. Screw in knife screw and , remove
knife holders, then screw in knife screw
and
b
b
c
e
d
d
a
8. Return the knife lever to its starting position
and lock it.
9. Take out knife screw
10. Loosen knife holder (only half turn) and
lower the knife downwards from
the knife carrier.
11. Take off worn blade to replace a new knife.
b
d
a
b
d
b
c
d
e
1. Knife lever
2. Front safety guard
3. Paper alignment
4. Knife
5. Blade-housing Cover
6. Clamping lever
7. Side gauge with scale
8. Back gauge (stop paper)
9. Knife Adjustment device
10. Stand
11. Light switch
12. Cutting stick
13. Rear safety guard
The grip of the knife lever has been careful packed with machine together. Please
install these items right away.
The guillotine: Top part and stand of the machine have to be connected as follows:
Set up the stand in a way that the 4 threaden pins point upwards.
Assemble the stand by matching the color label on each corresponding part.
Place the table correctly onto the machine stand.
Fit the washers and tighten the hexagonal nut with a 13 m/m wrench.
Fit two batteries (Size D) into the battery holder into the battery holder on the underside of the chassis.
3
8
INSTALLATION
Fig A
1. Put the knife lever to its top position about 90
degree and loosen the knife lever to take it off.
90
˚
a
b
b
c
d
e
4. Put the knife lever downwards to be horizontal.
5. Remove knife screws and and replace
them with the two knife holders from the tool
box. Thighten secruely.
6. Take out knife screws and
b
c
e
d
a b
2. Remove the screws in front safety guard and
cover (screw )
3. Take off blade-housing cover and front safety
guard.
You will find these symbols on batteries which contain harmful substances:
Pb=Battery contains lead
Cd=Battery contains cadmium
Hg=Battery contains mercury
Pb
Cd
Hg
Battery replacement:
If the light quality gets poor, you should replace the battery. Please
replace the old batteries by a fitting new one.
Battery disposal
Batteries should not be considered as regular garbage. As consumer you
are obliged to return finished batteries. The finished batteries can be
returned to a collection base at your residential area or at places, where
batteries can be bought.
WE RECOMMEND THE USE OF ALCALI-MANGAN BATTERIES.
Noted:On the diagonals under the machine table, putting a piece of iron plate obliquely and
screwing in the machine table tightly. When assembling the machine table with the stands,
the screw on the top of the stand must aim at the triangle hole accurately to fix. And then
screwed the washer tightly to avoid the machine table falling.
