KVH Industries tracvision tv8, Руководство по установке

Страница: 22 / 51

21
DIRECTV Latin America Wiring
Follow these steps to connect DIRECTV Latin
America receivers to the TracVision system
(DIRECTV L.A. circular LNB required) .
Connecting 1 Receiver
Connect an RF cable from the “Receiver” jack on
the TV-Hub to the “Satellite In” jack on the
receiver (see Figure 30).
Connecting Multiple Receivers
a. Run a second RF cable (RF2) from the
antenna (see “Wire the Antenna” on page 9 ).
Be sure to connect a grounding block in-line
with the RF1 and RF2 cables from the antenna
(see Figure 31 and “Grounding
Requirements” on page 25 ).
b. Connect the RF2 cable from the grounding
block to the “13V” jack on the power inserter
( supplied in kit ).
c. Connect the “V-OUT” jack on the power
inserter to the “18V” jack on the multiswitch
( supplied in kit ).
NOTE: If you need to connect more than four
receivers, install a multiswitch that has more outputs.
KVH offers an 8-output multiswitch (KVH part no.
19-0573).
d. Set the power inserter’s switch to the
“17/18V-HORZ, 13/14V-VERT” position.
e. Connect the “Receiver” jack on the TV-Hub
to the “13V” jack on the multiswitch.
f. Connect the multiswitch outputs to the
“Satellite In” jacks on the receivers.
g. Terminate any unused outputs on the
multiswitch with 75

terminators and verify
all connections are tight.
TV-Hub
AC Power
DIRECTV L.A. Receiver
Satellite In
Receiver
Antenna
RF1
Figure 30: Wiring 1 DIRECTV Latin America Receiver
Figure 31: Wiring Multiple DIRECTV Latin America Receivers
TV-Hub
Power
Inserter
Connect up to 4 receivers
Terminate
unused
outputs
Grounding
Block
Receiver
Antenna
AC Power
Satellite In
18V
13V
RF1 RF2
13V
V-OUT
AC Power
DIRECTV L.A. Receiver
13V 18V
Multiswitch
Set switch to:
17/18V-HORZ.
13/14V-VERT.
Continued
Wire the Receivers
11