KVH Industries TracPhone V11IP, Руководство по установке

Страница: 45 / 55

44
5. Using a utility knife, carefully remove any
residual plastic from the center conductor, if
necessary (see Figure 88).
6. Insert the end of the cable into the #2 end of
the ST-400EZ stripping tool (see Figure 89).
Then rotate the tool clockwise around the
cable until the tool turns easily. This removes
the cable jacket from the end of the cable,
exposing the braid and dielectric (see
Figure 90).
7. Using the DBT-02 tool, deburr and chamfer
the center conductor (see Figure 91). Avoid
nicking the aluminum tape covering the
dielectric.
Figure 88: Removing Plastic Residue
Figure 89: Stripping the Cable Jacket
Figure 90: Cable Stripped, Exposing Dielectric
Figure 91: Deburring the Center Conductor
Continued
Terminating LMR RF Cables
A
Appendix