Junction Box
Use the four #6 mounting screws to mount the junction box. The screw holes are only
accessible from the inside of the junction box. To install:
1. Unscrew the four screws on the top of
the junction box and carefully let the
cover hang down.
2. Let the cover hang down, trying not to
strain the ribbon cable that goes to the
power/light switch and the damping
control knob which are located in the
cover.
3. Mark where the holes are in the box and
drill 7/64" holes. Position the junction box
over the holes, insert the four #6 screws
and tighten securely.
4. Replace the cover and tighten the cover screws. The waterproof seal is reinstated
by tightening the cover screws as the mounting screws lie outside the inner rubber
gasket.
Remote Keypad
After you have carefully chosen a relatively flat surface for the remote keypad, follow
these instructions carefully:
Note:
If it is impossible to reach underneath the keypad to put nuts on the studs, you may
have to build a mounting plate that you can screw in from the top.
1. Tape the template provided at the back of this manual to the spot where you want
to mount the keypad. Use a center punch on the crosshairs indicated on the tem-
plate.
2. Drill the two 5/32" holes for the enclosed 6-32 studs. Then drill the 3/4" hole
for the cable. The hole must be large enough so that the cable clamp on the back of
the keypad can pass through.
Never try to loosen the cable clamp or remove the
connector from the cable.
3. Screw the two 6-32 studs into the back of the keypad. Check if the keypad slides
easily into the two holes. Correct the hole positions if necessary.
Do not force the
keypad if the holes don't line up!
4. Remove the keypad, apply some silicone-type sealant around each hole and push
13
INSTALLATION
Insert screws
in inner holes
