10
Follow the instructions below to mount the LNB
assembly onto the rear of the reflector.
a.
Note the position of the mounting pins (see
)and the LNB assembly’s mounting
).
b.
Rotate the upper feed (see
the LNB mounting pin holes with the
mounting pins on the LNB assembly (see
).
c.
Place the skew belt over the reflector hub (see
)
d.
Slowly insert the motor pulley inside the belt
loop, while aligning the phase cards and
mounting pins with the mounting holes (see
).
To avoid damage, handle the LNB assembly
extremely carefully. All three phase cards
must remain intact to complete the
installation.
IMPORTANT!
Mount the LNB Assembly
Figure 14 Mounting Pins
Figure 15 Assembly Mounting
Figure 16 Upper Feed Rotation
Mounting
Pin (x2)
RF Connectors
Gyro Bracket
Belt
6
