KVH Industries Ka Tri-Americas LNB, Руководство по установке

Страница: 4 / 19

5
Follow the instructions below to disconnect the
RF cables from the LNB.
a. Using cutting pliers, cut the tie-wrap securing
cables to the bottom of the LNB (see
Figure 4 ).
b. Using a Phillips screwdriver, remove the
screw and nut securing the P-clip on the
bottom of the LNB (see Figure 4 ).
c. If your LNB includes a connector plate (see
Figure 5 ), cut and remove the tie-wrap
securing it in place. Then remove the plate.
d. If your LNB does not include a connector
plate, using cutting pliers, cut the tie-wrap
securing the three RF cables on the top of the
LNB (see Figure 6 ).
e. Using 7/16" open-end wrench, disconnect the
four RF cables from the LNB (see Figure 5 or
Figure 6 ).
Disconnect the RF Cables
Figure 4 Tie-wrap/P-clip Removal
Figure 5 RF Cables/Connector Plate/Tie-wrap
Figure 6 RF Cables/Tie-wrap
Tie-wrap
P-clip Screw
and Nut
LNB
Connector Plate
RF Connector
(x4)
Tie-wrap
RF Connector
(x4)
Tie-wrap
3