KVH Industries Ka Tri-Americas LNB, Руководство по установке

Страница: 11 / 19

12
Follow the instructions below to set the motor
belt tension.
a. Adjust the skew motor on the bracket to
achieve moderate belt tension. Using a
2.5 mm ball-end hex wrench, tighten the
motor screws to secure the motor in place
b. Using a scribe, mark the resting location of
the belt against the reflector midway between
the hub and the pulley (see Figure 19 ).
c. Using a scribe and ruler, measure 1/8"
outward from the scribe mark you just
created (see Figure 19 ). This marks the
desired belt deflection distance.
d. Using the supplied tension meter, secure the
belt at the midway point. Then pull the belt
outward using 2 lbs of force (see Figure 20 ).
e. Reference the scribe marks in relation to the
belt position. Adjust the motor position, as
required, to ensure the belt deflection is 1/8"
using 2 lbs of force.
f. Using a 2.5 mm ball-end hex wrench, fully
tighten the four motor screws (see Figure 21 ).
Set the Belt Tension
Figure 19 Belt Tension Adjustment
Figure 20 Belt Tension Measurement
Figure 21 Motor Screws
Scribe Mark
(Deflected)
Midway
Point
Reflector
Pulley
Hub
Scribe Mark
(Resting)
Motor
Motor
Screw (x4)
7