3
Step 4 - Connect to the Web Interface
Choose one of the following methods to connect to
the TV-Hub’s web interface:
• Using any Wi-Fi-enabled mobile device (such as
a smartphone, tablet, or laptop), select the
TV-Hub-<TV-Hub serial number>
network
from your device’s Wi-Fi settings. Then start
your web browser and enter
http://tvhub.kvh
.
• Connect your computer to the onboard network
and enter the TV-Hub’s IP address in your web
browser. (The IP address can be found on the
Settings
page of the web interface.)
Step 5 - Configure the IP AutoSwitch
Follow these steps to configure the IP AutoSwitch.
NOTE: KVH recommends that you run the Setup
Wizard in the web interface whenever you change your
system’s configuration by adding or removing devices.
a.
At the AutoSwitch page of the web interface,
select
Add IP AutoSwitch
(Figure 4).
b.
Enter the serial number and a friendly name for
the IP AutoSwitch (for example, “Salon”).
c.
Select
Save
to save changes.
Step 6 - Select a Master Receiver
Any receiver connected to an IP AutoSwitch can
become the master receiver for the system. The
master receiver controls satellite selection.
a.
To choose a master receiver, select it at the
Home page of the web interface, or press the
Master Select button on the associated
IP AutoSwitch.
b.
Verify that the LED in the Master Select button
on the IP AutoSwitch is lit green (see Figure 5).
The LEDs for any other IP AutoSwitches should
be lit orange.
The installation procedure is complete!
Important!
The TV-Hub has a built-in IP AutoSwitch. Any
receiver connected directly to the TV-Hub can
therefore be selected as a master receiver through
the web interface.
Figure 4: Add IP AutoSwitch Screen
Figure 5: IP AutoSwitch LED Status Indications
LED Color
Indication
Orange
Registered with the system but
not currently the master
Orange,
flashing
Initializing
Red
Error:
• unable to communicate with
the system,
• network is not detected, or
• unable to register
Green
Registered with the system
and currently the master
