Kvaser Memorator Pro 5xHS User’s Guide
18 (27)
Figure 8: The HD26-5xDS9 Splitter
4.5
CAN bus termination
Every CAN bus must be terminated with a 120 Ohm resistor at each end of the
bus. The Kvaser Memorator Pro 5xHS does not contain any CAN bus termination,
because their inclusion could cause severe disturbance in a system which is
already correctly terminated.
For laboratory or testing use, the exact value of the termination resistors is not
always critical. Sometimes a single terminator is sufficient. For production, proper
termination is essential. If you see error frames on the bus, you should check the
termination.
To save yourself a lot of trouble, always terminate the CAN
bus properly.
4.6
External trigger input
The Kvaser Memorator Pro 5xHS can be set up to trigger on an external signal and
can be configured to react on both falling and rising edges.
Kvaser AB, Mölndal, Sweden — www.kvaser.com
