KVANT Burstberry, Руководство по эксплуатации

Страница: 15 / 34

2.8. Switching ON sequence and User
Interlock
1. Connect the system as showed on Connection Diagram .
2. Turn both E-STOP Remote and laser system safety keys to ON position.
3. Release the E-STOP button by pulling it upwards.
4. Open the aperture window by loosening the bolt at the right of the aperture, adjust the masking
plate to desired position and tighten the bolt to secure it.
5. Press the RESTART button on the E-STOP Remote.
Interlock Enabled, Laser Output Terminated
The Interlock is latched enabled and the laser projector’s beam output will be terminated if any of the
following events happen:
1. Power loss lasting greater than 2 seconds.
2. Mushroom emergency switch depressed.
3. #2 Key Switch on E-STOP Remote turned to OFF position.
4. #1 Key Switch on laser projector turned to OFF position.
5. Any other interruption to line No.1 of the cable leading to the E-STOP Remote.This includes any
user interlocks connected in series in the line No. 1 of this cable. Refer to Connection Drawing
below.
Please make sure that all laser display safety requirements are fulfilled in accordance
with laws of the country where this KVANT laser system is being used before switching
the system ON.
!
Kvant Lasers s.r.o. Burstberry - 1
Page 13 of 32