Kval Edge-SS, Руководство по эксплуатации

Страница: 142 / 152

Servo Motor and Valve Bank Locations
KVAL Operation Manual
5-16
Valve Bank Locations
Figure 5-7 shows the locations of the valve banks on the machine. The valve banks include con-
trol valves (solenoids) that drive cylinders to move different loads in the machine. The solenoid if
controlled by the PLC by applying a high voltage or a low voltage to a control coil. Controls for
example are: extending and retracting router, drill, clamping a door.
Valve banks are normally located near the load that they drive.
Note:
Labels on the solenoids identify loads they control.
Typical Valve Bank Controls
FIGURE 5-7.
Location of Valve Banks
The table below lists the typical loads controlled by the valve banks.
Note:
The values in this table are typical. To verify check the labels on the solenoids
and the air schematic.
TABLE 5-2.
Valve Bank Descriptions
Valve Bank Loads (Cylinders)
Table Valve Bank 1 Extend and Retract: Stops, Feeler, Dust Hoods, Lower Door
Table Valve Bank 2 Extend and Retract:; Clamps, Lift Table
Cutter Head Valve Bank Extend and Retract: Chisels (X4),Hinge Router, Router, CR Router, Deep Mortise
Deep Drill Bank Extend, Retract., and Lift, Air Inject for Deep Drill
Table Valve Bank 2
Table Valve Bank 1
Cutter Head Valve Bank
Deep Drill Valve Bank